This review is for the machine shop only. I had some machine work done on some 302 Ford heads and engine boring and cam bearings. The work was done probably about a year and a half ago and the car has been in build since then. It is a 1925 Model T Coupe with '68 Mustang running gear. It took about two months to get the parts back. They are so unorganized down there it's pathetic. I gave instructions to drill and pin the rocker studs. They didn't do it. They pulled them and installed screw-in studs. The person who did the work, used some sort of white stuff on the studs?? It was not Loctite. I started the engine for the first time over the weekend and it ran for about 45 seconds before the rocker studs broke loose and have unscrewed themselves. This would not have happened if they had done what I told them to do. I cannot trust any of the machine work that they did on the heads. Total incompetence down there. Poor management in the machine shop, and they keep him there!!!
